The mobile lifting platform adopts hydraulic chain intermodal mode. Three groups of mast-supported operation platforms are lifted and lowered synchronously, with excellent working stability. Beautiful appearance, small size, light weight, flexible and convenient movement, safe and reliable lifting operation.

可折疊式護欄，閑置時護欄可向下折疊降低自身高度，節省空間，作業時安裝簡潔便利。 升降操作設兩套按鈕，工作臺面與臺下都可控制。

Foldable guardrail. When idle, the guardrail can be folded down to reduce its height, saving space, and easy to install during operation. The lifting operation is equipped with two sets of buttons, which can be controlled on the working table and under the table.

框架采用矩形管焊接成型。 升降柱采用高強度鋁合金型材，結構緊湊，并采用雙鏈條牽引，系數大。 平臺上升到高位置時有極限限位。

The frame is welded with high-quality rectangular tube. The lifting column is made of high-strength aluminum alloy profile, with compact structure and double chain traction, with high safety factor. There are limit stops when the platform rises to the high position.

產品應用:鋁合金高空作業平臺適用于賓館飯店室內裝修布置空間燈線管路門窗的維修保養及清潔，并適用于面積或空間狹窄房內的空間作業。

Product application: The aluminum alloy aerial work platform is applicable to the maintenance and cleaning of the interior decoration and layout of the space light lines, pipelines, doors and windows of the shopping malls, hotels and hotels, and is applicable to the space work in the rooms with narrow area or space.

一 操作使用

I. Operation and use

在作業前將支撐臂打開到135°，旋轉支腿絲缸，將底座調水平，系好繩，檢查行程開關是否牢固靈敏，上控制按鈕是否正常，便可操作平臺升降，升工作高度作業時工作人員必須配帶帶，并鎖緊在身體和牢固的物體上。

Before operation, open the support arm to 135 °, rotate the outrigger screw cylinder, adjust the base to the horizontal, fasten the safety rope, check whether the travel switch is firm and sensitive, and whether the upper control button is normal, then the platform can be operated for lifting and lowering. When working at the working height, the staff must wear the safety belt and lock it on the body and solid objects.

升降操作：分為上下控制升降手電兩用，按標注符號進行操作，使用前檢察手壓閥是否關閉，當作業時突然停電，可松開手壓泵閥，升降機此時緩慢下降到低位置。

Lifting operation: It can be divided into two functions: up and down control, lifting and flashlight. Operate according to the marked symbols. Before use, check whether the hand pressure valve is closed. When the power is suddenly cut off during operation, release the hand pressure pump valve. At this time, the lift slowly lowers to the low position.

升降機作業時，電源線直徑不的小于4平方mm，長度不的超過20米。

During elevator operation, the diameter of the power cord shall not be less than 4 square mm and the length shall not exceed 20 meters.

作業時勿將物品掉入滑道內。

Do not drop objects into the slide during operation.

不準超載作業。

Overloading operation is not allowed.

移動式升降機未降到低位置，不準移動整機。

The mobile elevator is not allowed to move the whole machine until it is lowered to the low position.

風雨天氣禁止室外作業。

Outdoor operation is prohibited in rainy weather.

二 注意事項：

2. Precautions:

升降機拆裝時機體要垂直防止主體變形和漏油現象。

When disassembling the elevator, the body should be vertical to prevent the main body from deformation and oil leakage.

工作人員注意隨身攜帶的工具和零部件，不要掉入支撐架內，防止卡壞鏈條。

The staff should pay attention to the tools and parts they carry with them, and do not fall into the support frame to prevent the chain from getting stuck.

使用該機前空升一次，仔細觀察各部位是否正常有無異常聲音，一經發現，應停止使用;由維修人員調試好后使用(電器元件保修三個月)。

Before using the machine, lift it once in the air, carefully observe whether each part is normal or abnormal, and stop using it once it is found; It shall be used after debugging by professional maintenance personnel (electrical components are guaranteed for three months).

三日常維護保養：該機為室內機，在室外使用時應在地質堅硬的地面上使用，以免發生顛覆，每使用20次調整一次鏈條螺絲調整一次保險繩螺絲，電器及液壓系統應由人員維修。

III. Daily maintenance: This machine is an indoor machine. When used outdoors, it should be used on the hard geological ground to avoid overturning. The chain screw should be adjusted once every 20 times to adjust the safety rope screw. The electrical and hydraulic system should be repaired by professionals.